Advertisement
SPEAKER CONNECTIONS: Screw wires onto connector block, with wires
attached as follows: (From Left to Right): first slot Left (-), second slot Left (+),
Third slot Right (-) and fourth slot Right (+) For mono operation use Left (+) and
Right (-). These amplifiers are capable of 2-ohm operation in stereo or 4 ohms
in mono.
OPERATING THE AMPLIFIER AT LESS THAN THESE RATINGS WILL
CAUSE AMPLIFIER FAILURE AND VOID YOUR WARRANTY.
NOTE: The 452i
have internal speaker protection fuses. If there is no output
©
from the amplifier, check these fuses, as your warranty does not cover their
replacement. Replace fuses only with fuses having the same rating. The
proper fuse is a GMA-5, 5-amp fuse per channel. Some later model amps may
use an ATC 5-amp fuse.
IMPROPER FUSING WILL DAMAGE YOUR AMPLIFIER!
2-Channel Stereo Operational Diagram
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
2
LINEAR POWER™ is a trademark of Linear Power, Inc.
Advertisement
