Makita GA004G Instruction Manual page 10

► 1. Wheel guard 2. Hole
Installing or removing depressed
center wheel or flap disc
Optional accessory
WARNING:
When using a depressed center wheel or
flap disc, the wheel guard must be fitted on the tool so that the
closed side of the guard always points toward the operator.
CAUTION:
Make sure that the mounting part of the
inner flange fits into the inner diameter of the depressed
center wheel / flap disc perfectly. Mounting the inner flange
on the wrong side may result in the dangerous vibration.
Mount the inner flange onto the spindle.
Make sure to fit the dented part of the inner flange onto
the straight part at the bottom of the spindle.
Fit the depressed center wheel / flap disc on the inner
flange and screw the lock nut onto the spindle.
2
3
► 1. Lock nut 2. Depressed center wheel 3. Inner
flange 4. Mounting part
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
1
2
► 1. Lock nut wrench 2. Shaft lock
To remove the wheel, follow the installation procedure
in reverse.
Installing or removing flex wheel
Optional accessory
flex wheel is on tool. Wheel can shatter during use
and guard helps to reduce chances of personal injury.
► 1. Lock nut 2. Flex wheel 3. Back up pad 4. Inner
Follow instructions for depressed center wheel but also
use back up pad over wheel. See order of assembly on
accessories page in this manual.
1
4
10 ENGLISH
1
2
WARNING:
Always use supplied guard when
1
2
3
4
flange