Rear Mounting - Blower Motor - Whirlpool UXD8636DYS Installation Use & Care Instructions

NOTE: Optional blower motor rear-mounting position (opposite
side) for island cabinet location. The blower motor box assembly
can be moved to the opposite side (rear) of the vent box.
1. Remove seven screws from the mounting flanges of the
blower motor box.
Front View
A
C
A. Screws (7)
B. Keyhole slot shoulder screws (2)
C. Blower motor box
A
A. Blower motor box
2. Lift blower motor box off the shoulder screws in the keyhole
slots. Disconnect wire connection from blower motor and set
blower motor box aside.
3. Remove six screws from the mounting flange of the 1/4"
(6.4 mm) deep cover.
12
Rear Mounting — Blower Motor
A
A
B
Rear View
C
A. Screws (6)
B. Keyhole slot shoulder screws (2)
C. 1/4" (6.4 mm) deep cover
A. Deep cover
4. Lift the 1/4" (6.4 mm) deep cover off the shoulder screws
in the keyhole slots and set the cover aside.
5. Remove the screws from the wire-mounting plate.
A
B
A. Screws
B. Wire-mounting plate
C. Blower motor box
A
B
A
A
C