LG F8068QD Series Owner's Manual page 18

H
ow to use washer
Child Lock
If you choose to lock the buttons on the control
assembly to prevent tampering this function
may be selected.
• Child Lock can be set by pressing the Medic
Rinse button and Pre Wash button
simultaneously. (About three seconds)
• To deactivate Child Lock system, press
Medic Rinse and Pre Wash buttons
simultaneously again. (About three seconds)
• To change to the desired program, whilst in
child lock mode.
1. Press both Medic Rinse and Pre Wash
together once again. (About three seconds)
2. Press the Start/Pause button.
3. Select the desired program and press the
Start/Pause button again.
• The child lock can be set at any time and it
can be deactivated only by using child lock
cancel process. Turning the power off and
operational errors will not affect child lock.
18
Change
the desired
program
Time Delay
Time Delay
Preparing washing before starting
"Time Delay"
- Turn on the water tap.
- Load laundry and close the door.
- Place the detergent and fabric softener in the
drawer.
• How to set "Time Delay"
- Press Power button
- Turn the Program dial to select the program
you require.
- Press Time Delay button and set the desired
time.
• Each pressing of the button advances on
time delay by 3h,6h,9h
• Time Delay is "expected time" from the
present to completion of Washing cycle or
selected process (Washing, Rinse, Spin)
•
According to the condition of water supply and
temperature, the delay time and the actual
washing time may vary
• How to Display
The lamps are used to indicate both 'time delay'
and 'washing process'
"3h,6h,9h" icon is used to show how much time
is delayed.
"Washing,Rinse,Spin" icon is used to show the
washing cycle in process.
1. When you set the 'time delay'
- Lamp above the desired time will blink.
Ex) If you've selected 6 hours time delay, the
lamp above "6h" icon will blink, and after 3
hours the lamp above '3h' icon will blink.
- After the designated time has elapsed,
depending on the course selected the lamp of
proceeding process will blink.
2. During regular operation.
If you turn on the power, all three lamps will turn on.
Depending on the course you select only the
lamp above the related process will be left on.
- When you begin the designated course by
pushing the 'start/pause'button, the lamp of
proceeding process will blink.
Time Delay