Installation Kit; Installation Steps - Honeywell MM14 Series User Manual

INSTALLATION

Installation Kit:

1. Window Bracket Kit.............................
2. Window Bracket Panel Adapter...........
3. Hose Connector..................................
4. Plastic Hose........................................

Installation Steps:

1. Install the plastic hose with window bracket adapter and hose connector on both sides. Ensure
proper fit on both ends.
2. The Window Brackets are approximatley 72 cm / 28.3 inches each, allowing you to install to
windows and balcony doors of different heights or width.
Butterfly Screws
3. Connect the plastic hose to the rear exhaust
outlet on the back of the unit. Push-in until it is
locked in place.
4. Connect the window bracket to the opposite
end of the plastic hose. Ensure that all
connections are tight and installed properly.
1 Set
1 Piece
1 Piece
1 Piece
2 m / 78.7"
3 parts
72 cm / 28.3" to
135 cm / 53.1"
2 parts
28.3"
72 cm
1 part
5. Connect the window bracket to the window.
6. The Portable Air Conditioner is now ready to
EN
1 2
4
x 1
To install the window bracket to the
window frame, you need to adjust the
height or width of the window bracket by
extending the length according to the
height or width of the window or balcony
door. When the length is set, tighten the
butterfly screws (preinstalled on the
window bracket) to ensure the window
bracket is secured in the desired position.
Use one or all three pieces of window
bracket as needed.
use.
3
x 1
x 1
x 1
3