Care And Maintenance - Nexgrill 720-0864M Owner's Manual

STAINLESS STEEL
There are many different stainless steel cleaners available.
Always use the mildest cleaning procedure first, scrubbing in
the direction of the grain. Do not use steel wool as it will
scratch the surface. To touch up noticeable scratches in the
stainless steel, sand very lightly with dry 100 grit emery paper
in the direction of the grain. Specks of grease can gather on
the surfaces of the stainless steel and bake on to the surface
and give the appearance of rust. For removal use a mild
abrasive pad in conjunction with a stainless steel cleaner.
GRILL GRATE
The easiest way to clean the grill is immediately after cooking
is completed and after turning off the flame. Wear a barbeque
mitt to protect your hand from the heat and steam. Dip a brass
bristle barbeque brush in water and scrub the hot grill. Dip the
brush frequently in the bowl of water. Steam, created as water
contacts the hot grill, assists the cleaning process by softening
any food particles. If the grill is allowed to cool before cleaning,
cleaning will be more difficult.
ENSURE THAT THE GAS SUPPLY AND THE KNOBS ARE
BURNER IS COOL BEFORE REMOVAL.
GRILL BURNERS
Extreme care should be taken when moving a burner as it
must be correctly centered on the orifice before any attempt is
made to relight the grill. Frequency of cleaning will depend on
how often you use the grill.
MAIN GRILL BURNER CLEANING
position. Make sure the grill is cool. Clean the exterior of the
burner with a wire brush. Clear stubborn scale with a metal
scraper. Clear any clogged ports with a straightened paper
clip. Never use a wooden toothpick as it may break off and
clog the port. Please note if insects or other obstructions are
blocking the flow of gas through the burner, and if so you will
need to call our customer service line U.S.A:1-800-913-8999.
GREASE TRAY CLEANING
The grease tray should be emptied and wiped down
periodically and wash with a mild detergent and warm water
solution. A small amount of sand may be placed in bottom of
grease tray to absorb the grease. Check the grease tray
frequently, do not allow excess grease to accumulate and
overflow out of the grease tray.
CAUTION
1. Keep outdoor cooking gas appliance area clear and free
from combustible materials, gasoline and other
flammable vapors and liquids.
2. Do not obstruct the flow of combustible and ventilation air.
3. Keep the ventilation openings of the cylinder enclosure
free and clear from debris.

Care and Maintenance

Warning: If you wish to replace main burner, we
strongly recommend that you hire a
professionally trained technician to replace it.
Please understand that we will not be responsible
for any liability, personal injury, or property
damage resulting from an improperly assembled
burner.
HOW TO REPLACE MAIN BURNER
Step 1. Remove the two screws and the cotter clip that
hold the burner in place. Set aside the screws and pin.
Remove the burner from the grill by lifting the burner out.
Step 2. Reinsert the new burner onto the orifice, as shown
below, make sure burner hole aim at orifice. Repeat the
procedure for the each burner.
Step 3. Reattach gas burner using screws and cotter pin.