IBM 8233-E8B Manual page 111

4. Press F4.
5. Select digiasync, then press Enter.
6. Use the cursor to scroll to ACCEPT new license agreement
7. Press F4.
8. Select Yes, then press Enter.
When installation commences, do not interfere until the installation completes. A successful
installation will return an OK message. An unsuccessful installation will return a FAILED message.
If you receive an OK message, continue to the next step. If you receive a failed message, review the
smit.log file to determine why the installation failed.
9. Press F10.
10. Type: lslpp -l | grep digi
If the Digi RealPort package installed correctly, you will receive a message. The following are
examples of return messages:
v digiasync.realport.obj 3.8.7.0 COMMITTED Digi RealPort Driver
v digiasync.realport.obj 3.8.7.0 COMMITTED Digi RealPort Driver
11. After the Digi RealPort Software is installed, the user may configure the 7036-P16 onto the network,
if it is not already configured. For instructions on how to perform the network configuration, see
"Configuring the 7036-P16 into the network" on page 100.
Installing the Linux SUSE Digi RealPort software
To install the software package for the Linux SUSE environment, do the following steps:
1. Log in to the server as the root user.
2. If the CD-ROM is already inserted and mounted, then proceed to step 5.
3. Insert the CD-ROM into the CD-ROM drive.
4. Type: mount -t auto /dev/cdrom /mnt
5. Type: cp /mnt/linux/40002086_M.src.rpm /usr/src/packages/SOURCES
6. Type: umount /mnt
7. Type: cd /usr/src/linux
8. Type: make mrproper
9. Type: make oldconfig
10. Type: cd /usr/src/packages/SOURCES
11. Type: rpmbuild --rebuild 40002086_M.src.rpm
12. Type: rpm -i /usr/src/packages/RPMS/ppc64/dgrp-1.9-6.ppc64.rpm
13. Type: rpm -qa | grep dgr
If the Digi RealPort Package installed correctly, the following is an example of the return message:
dgr-1.9.6
14. After the Digi RealPort software is installed, the user may configure the 7036-P16 onto the network,
if it is not already configured. For instructions on how to perform the network configuration, see
"Configuring the 7036-P16 into the network" on page 100.
Installing the Linux Red Hat Digi RealPort software
To install the software package for the Linux Red Hat environment, do the following steps:
1. Log in to the server as the root user.
2. If the CD-ROM is already inserted and mounted, then proceed to step 5.
3. Insert the CD-ROM into the CD-ROM drive.
4. Type: mount -t auto /dev/cdrom /mnt
97
Managing devices