HOME NETWERKS 7130-03-BT Manual page 5

PREPARATION
Tools Required for Assembly (not included): Hammer, Flathead Screwdriver, Wire Nuts, Nails, Duct Tape,
Phillips Head Screwdriver, Utility Knife
Helpful Tools (not included): Electric Drill, Drill Bits
WARNING: Turn off electricity at breaker box before beginning installation.
Carefully remove unit from carton.
Check area above installation location to be sure that wiring can run to the planned location and that
duct work can be run and the area is sufficient for proper ventilation.
Inspect duct work and wiring before proceeding with installation.
Before installation, provide inspection and future maintenance access at a location that will not interfere
with installation work.
You may need the help of a second person to install this fan; one person on the attic side and one on
the room side.
Note: Installations may vary depending on how the previous bath fan was installed. Supplies necessary
for the installation of your bath fan are not all included; however, most are available at your local
home improvement or hardware store.
DIMENSIONS REQUIREMENTS
Ceiling
Opening (L) Opening (W)
9.4 in.
WIRING DIAGRAM
Capacitor
MOTOR
www.homewerksww.com
Ceiling Ceiling
Opening (H)
9.4 in. 7.4 in.
Bluetooth speaker
®
Controller
FAN HOUSING
Housing
Dimension (L)
9.25 in.
Black wire
White wire
Green wire
5
Housing Housing
Dimension (W) Dimension (H)
9.25 in. 7.3 in.
to switch
to neutral
to ground