Illustration Of One-Piece Door Installation - Chamberlain 1200 Owner's Manual

Chamberlain owner's manual garage door opener 1200
Hide thumbs Also See for 1200:
Table of Contents

Advertisement

One-Piece Door Installation
Before you begin, survey your garage area to
see whether any of the conditions below
apply to your installation.
Header
Wall
Gap between floor and bottom of
Safety
door must not exceed 1/4".
Reversing
Sensor
Based on your particular requirements, there are
several installation steps which might call for
materials and/or hardware not included in the carton.
• Step 1, page 12 - Look at the wall or ceiling above
the garage door. The header bracket must be
securely fastened to structural supports.
• Step 5, page 17 - Do you have a finished ceiling in
your garage? If so, a support bracket and additional
fastening hardware (not supplied) may be required
• Safety reversing sensor, page 21 - Depending on
garage construction, wood blocks may need to be
securely fastened to mounting locations before
sensors are installed.
• Step 10, page 22 - Alternate floor mounting of the
safety reversing sensor will require hardware that is
not provided.
• Step 11, page 25 - Generally, a one-piece door
does not require reinforcement. If your door is
lightweight, you can refer to the information relating
to sectional doors on page 24.
• Step 11, page 25 - Depending on your door's
construction, you might need additional mounting
hardware for the door bracket.
• Do you have an access door in addition to the
garage door? If not, Model 1702 Outside Quick
Release is required. See page 38.
• The gap between the bottom of the garage door and
the floor cannot exceed 1/4". Otherwise, the safety
reverse system may not work properly. See
page 30. The floor or the door should be repaired.
Access Door
Safety Reversing Sensor
5
One-Piece Door without Track
Chain
Pulley Bracket
Header
Bracket
Door
Bracket
Garage
Door
Header
Wall
One-Piece Door with Track
Slack in Chain Tension
is Normal When
Garage Door is Closed
Floor must be level
Safety
across width of door
Reversing
Sensor
Closed Position
Chain
Pulley
Bracket
Header
Wall
Header
Bracket
Door
Bracket
Door
You may find it helpful to refer back to this page as
you proceed with the installation of your opener.
Closed Position
Trolley
T-rail
Manual
Release
Straight
Curved
Rope & Handle
Door
Door
Arm
Arm
Access
Door
Safety
Reversing
Sensor
Chain
Trolley
Curved
Door Arm
Manual Release
Rope & Handle
Straight
Door Arm
T-rail

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents