Do you have a question about the PC-WAL4 and is the answer not in the manual?
Questions and answers
Robyn Detert
January 25, 2025
I put water in for first use. Plugged in & it lit up. I do not have manual. Need to run 15 mins but no start button. How do you start it?
1 comments:
Mr. Anderson
February 10, 2025
Before using the Power Cooker PC-WAL4 for the first time, follow these steps:
1. Wash Components – Clean the INNER POT, LID, and RUBBER GASKET with warm soapy water, rinse, and dry thoroughly. 2. Check the RUBBER GASKET – Ensure the RUBBER GASKET is properly seated inside the LID. 3. Insert INNER POT – Place the INNER POT into the unit, ensuring it does not exceed the MAX fill line. 4. Test Fit – Fill the INNER POT about 1/5 full with water to check the RUBBER GASKET’s fit. 5. Close the LID – Properly secure the LID. The MAGNETIC SAFETY SENSOR will beep and display “LID” if it is not fully closed. 6. Power On – Plug in the unit and select a desired cooking mode from the Digital Display. 7. Adjust Settings – Set cooking time and pressure level as needed. 8. Start Cooking – Begin the cooking cycle. The unit will automatically switch to KEEP WARM mode after cooking.
Need help?
Do you have a question about the PC-WAL4 and is the answer not in the manual?
Questions and answers
I put water in for first use. Plugged in & it lit up. I do not have manual. Need to run 15 mins but no start button. How do you start it?
Before using the Power Cooker PC-WAL4 for the first time, follow these steps:
1. Wash Components – Clean the INNER POT, LID, and RUBBER GASKET with warm soapy water, rinse, and dry thoroughly.
2. Check the RUBBER GASKET – Ensure the RUBBER GASKET is properly seated inside the LID.
3. Insert INNER POT – Place the INNER POT into the unit, ensuring it does not exceed the MAX fill line.
4. Test Fit – Fill the INNER POT about 1/5 full with water to check the RUBBER GASKET’s fit.
5. Close the LID – Properly secure the LID. The MAGNETIC SAFETY SENSOR will beep and display “LID” if it is not fully closed.
6. Power On – Plug in the unit and select a desired cooking mode from the Digital Display.
7. Adjust Settings – Set cooking time and pressure level as needed.
8. Start Cooking – Begin the cooking cycle. The unit will automatically switch to KEEP WARM mode after cooking.
This answer is automatically generated