Advertisement
Before You Start
Thank you for purchasing Synology FS3017 Expansion Card (FXC17). With FXC17, your FlashStation FS3017
can connect to RX1217sas/RX2417sas for drive expansion. Before installing FXC17, please power off your
FlashStation, and unplug the power cord from it. Also, make sure to read the safety instructions carefully to avoid
harming yourself or damaging your Synology products.
All images below are for illustrative purposes only, and may differ from the actual product.
Note:
Safety Instructions
Keep away from direct sunlight and away from chemicals. Make sure the environment does not
experience abrupt changes in temperature or humidity.
Place the product right side up at all times.
Do not place near any liquids.
Before cleaning, unplug the power cord. Wipe with damp paper towels. Do not use chemical or
aerosol cleaners.
To prevent the unit from falling over, do not place on carts or any unstable surfaces.
The power cord must plug in to the correct supply voltage. Make sure that the supplied AC voltage is
correct and stable.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Risk of explosion if battery is replaced with an incorrect type. Dispose of used batteries appropriately.
3 3
Chapter
1
Advertisement
