LG LRMDC2306 Series Owner's Manual page 17

2
Fit the hinge over the hinge lever latch
a
and slot it into place. Rotate the lever
counterclockwise to secure the hinge.
3
Connect all the wire harnesses
ground wire .
e
NOTE
• The number of wire harnesses may vary
depending on the model.
• Ground wire is only present on some models.
Assembling the Left Refrigerator
Door
CAUTION
• Install the left refrigerator door after the right
door is installed.
1
Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator
door onto the middle hinge.
2
b
c
3
and the
d
4
5
Fit the hinge over the hinge lever latch
a
and slot it into place. Rotate the lever
clockwise and fasten the hinge.
Connect all the wire harnesses and the
ground wire.
Push the water supply lines into the hole on
the top case and pull them through the
backplate.
Hold the water supply connection and gently
push in the collet to connect the water
d
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
place.
INSTALLATION 17
b
c