Advertisement
Step 3: Undo mandrel (17)
anticlockwise
4.2.
INSERTING RIVET NUTS refer to picture below
4.2.1.
Screw rivet nut onto the end of the mandrel (17) until it is level with the end of the guide cap (18).
4.2.2.
Insert the riveter into the hole and close the handles together to rivet the nut.The rivet needs to shorten by about 6mm.
4.2.3.
Pull the release knob (19) to release the mandrel (17) from the rivet.
5. MAINTENANCE
5.1.
Keep all pivots lightly oiled.
5.2.
The riveter should be cleaned and oiled at regular intervals, depending on the frequency of use.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
Step 4: Screw in new mandrel (17) clockwise.
Replace guide cap (18) and guide sleeve (16).
www.sealey.co.uk
AK3988 Issue 1
26/05/20
Advertisement
