Sealey SPI15S Instructions Manual page 10

17. TROUBlEShOOTINg
PROBlEM
Battery connectors do
not spark when touched
together.
the charger will not turn on
when properly connected.
i cannot select a language
on the display.
Green LED is lit and the
display shows ANAlyzINg
BATTery.
Green LED is flashing and
the display shows CHArge
ABOrTeD-BAD BATTery.
the display shows
CONNeCT ClAMPS.
18. SPECIFICATIONS
input ............................................................................................. 230V Ac~50/60Hz, 2.5A
output ............................................................................................................... 12V
ingress Protection rating ..............................................................................................iP20
POSSIBlE CAUSE
the charger is equipped with an
auto-start feature. it will not supply
current to the battery connectors
until a battery is properly connected.
the connectors will not spark if
touched together.
Ac outlet is dead.
Poor electrical connection.
Press the button for 5 seconds to
select a language:
(EN→ DE→ FR→ NL→ ES→ IT).
the charger needs to check the
condition of the battery.
The battery is too large for the
charger.
The battery voltage is still below
10V after 2 hours of charging.
the clamps are not making a good
connection.
The fuse is bad.
•
10
No problem; this is a normal
condition.
check for open fuse or circuit
breaker supplying AC outlet.
check power cord and extension
cord for loose fitting plug.
No problem; this is normal.
The green LED will be lit when the
charger is checking the condition of
the battery. This is normal.
You need a charger with a higher
amp rate.
Have the battery checked.
check for poor connection at
battery and frame.
replace the in-line fuse for the ring
connector.
•
SOlUTION
15A