Advertisement
Before using you r dishwasher for the first time :
A.
Set the water softener
B.
Add 1.5Kg dishw asher salt an d then full fill the salt con tainer with w ater
C.
Fill the rinse aid dispenser
D.
Fill in detergent
The water softener must be set m anually, using the water hard ness dial.
The water softener is des igned to rem ove minerals and salts from the water, which would have
a detrim ental or adverse effect on the operation of the app liance.
The more minerals there are, the harder your wate r is
The softener sho uld be adjusted according to the hard ness of the water in your area. Your local Water Authority
can advise you on the hardne ss o f the water in your area.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the amount of sa lt co nsumed bas ed on the ha rdness of
the water used. This is intended to op timise and customise the level o f salt consum ption.
Please follo w the steps below for adjustm ent in salt consumption.
1.
Wi th th e do or c lose d, switch on the appliance;
2. Touch the
setting mode within 60seconds after the applia nce was switched on(Salt and
Rinse aid warning lights will be on periodically
3.
Touch
th e setting will change in the following sequence: H1->H2->H3->H4->H5->H6->H1;
4. To end the setting mode, either touch the On/Off button or wait 5 sec onds
dH
0~5
6-11
12-17
18-22
23-34
35-55
1
dH=1.25 Clarke=1.78 fH =0.178mmol/l
dH:
German degree
fH:
French degree
Clark: British degree
The manufactory setting: H3 (EN 50242)
Contact your local water board for information on the hardness of your water supply.
If your model does not have any water softener, you may skip this section.
WATER SO FTENER
The hardness of the wa ter varie s from place to plac e. If hard water is used in the dishwasher, de posits will
form on the dish es and utensils.
The applian ce is equipped with a sp ecial softener that uses a salt container specifically des igned to eliminate
lime and minera ls from the water.
Start/pause
button for more than 5 se conds to start the wa ter softener
the
Start/Pause
button to select the proper set according to
WATER HARDNESS
fH
0~9
10-20
21-30
31-40
41-60
61-98
seeting mode is on
mmol/l
Clarke
0~6
0~0.94
7-14
1.0-2.0
15-21
2.1 -3.0
22-28
3.1-4.0
29-42
4.1 -6.0
43-69
6.1-9.8
7
);
the hardness of your local water
Salt con sumption
Sel ector Position
(gram/cycle)
0
H1
H2
9
H3
12
H4
20
30
H5
60
H6
,
Advertisement
