LG WD-T1213MRD Owner's Manual page 10

nstallation
I
Normal Tap without thread & screw type inlet hose
1.
Unscrew the fixing screw to
attach the tap.
Normal Tap without thread & one touch type inlet hose
1.
Un tighten the upper connector
screw.
Upper
Connector
Fixing screw
• In case the diameter of the tap is
large remove the guide plate.
Guide plate
Used the horizontal tap
Horizontal tap
Extension tap
Square tap
When the water supply hose is to be extended (Option)
• purchase the water supply hose for extension at the LG
electronics agent or service center.
Using [ the connector of the water supply hose ], connect it
to the water supply hose. (commercial item)
• When either of cold or hot water supply hoses is used, you
can connect the hose which is not used to [ the connector of
the water supply hose ].
Warning: Please don't connect the hot water only.
!
2.
Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
2.
Push the upper connector up till
the rubber packing is in tight
contact with the tap. Then
Rubber
packing
tighten the 4 screws.
Middle Rubber packing
connector
Upper
Connector
Middle
connector
• Turn the middle connector not
to have water leaked.
Connector
• Make sure that the rubber seal
is inside the hose connector.
Hose connector
3.
Push the water supply hose
vertically upwards so that the
rubber packing within in the
hose can adhere completely to
the tap and then tighten it by
screwing it to the right.
3.
Connect the water supply hose
to the middle connector,
pushing the plate down.
Upper
Connector
Water supply
hose
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
Rubber seal
• Make sure that there are no
kinks in the hose and that it is
not crushed.
Water supply hose
Plate
Water supply hose
The connector of the
water supply hose
9