Option D: No waste disposer –
with air gap
Screw-type clamps
Waste tee
Drain trap
1. Connect rubber end of drain hose
1
to air gap.
Rubber
end
2. Attach drain hose to air gap. Use a
2
1" to 1
clamp.
3
3. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.
COMPLETE INSTALLATION
Check that the power supply wire or cord does not touch
dishwasher motor or the lower part of the dishwasher tub.
20
Air gap
Large drain
hose clamp
Rubber hose
connector
Drain hose
/
" (2.5 to 3.8 cm) screw-type
1
2
48.
Power supply cord—Plug into
a grounded 3 prong outlet
Plug into a grounded 3 prong outlet.
49.
Reconnect power
Reconnect electrical power at the fuse box or circuit
breaker box.
NOTE: With the access panel off, start the dishwasher and allow
it to complete the shortest wash cycle. After the first 2 minutes,
unlatch door, wait 5 seconds, then open door. Check that there is
water in the bottom of the dishwasher tub. Check that dishwasher
is working properly.
REINSTALL ACCESS PANEL
50.
Reinstall bent access panel
Place the bent access panel against dishwasher legs.
51.
Install flat access panel in front of
bent panel
Place the flat panel in front of the bent panel. Using a Phillips
screwdriver install the screws through the holes in the access
panel.
Bent access
panel