Complete Installation; Reinstall Access Panel; Check Operation; If Dishwasher Does Not Operate - Whirlpool UDT518SAHP Installation Instructions Manual

COMPLETE INSTALLATION

Check that the power supply wire or cord does not touch
dishwasher motor or the lower part of the dishwasher tub.
48.
Power supply cord—Plug into
a grounded 3 prong outlet
Plug into a grounded 3 prong outlet.
49.
Reconnect power
Reconnect electrical power at the fuse box or circuit
breaker box.
NOTE: With the access panel off, start the dishwasher and allow
it to complete the shortest wash cycle. After the first 2 minutes,
unlatch door, wait 5 seconds, then open door. Check that there is
water in the bottom of the dishwasher tub. Check that dishwasher
is working properly.

REINSTALL ACCESS PANEL

50.
Reinstall panel
Place the panel against dishwasher legs. Using a Phillips
screwdriver or 1/4" nut driver, reinstall the screws through
the holes in the access panel.
51.
Secure with screws
Check that the lower edge of the access panel touches the floor.
Adjust if necessary.
Tighten access panel screws.

CHECK OPERATION

Read the dishwasher User Guide that came with your
■
dishwasher.
Check that all parts have been installed and no steps were
■
skipped. Check that you have used all tools.
If the dishwasher is not working properly, disconnect power
or unplug dishwasher and refer to the "If Dishwasher Does Not
Operate" section.

IF DISHWASHER DOES NOT OPERATE

First try the solutions suggested here to possibly avoid the cost
of a service call.
Has the circuit breaker tripped or the house fuse blown?
■
Is the door closed tightly and latched?
■
Has the cycle been set correctly to start the dishwasher?
■
Is the water turned on?
■
If none of these possible solutions work, please see the User
Guide for service contact information.

ADDITIONAL TIPS

Expect longer wash times. Your new dishwasher will average 2-5
hours per load but use nearly 40% less energy than older models.
Designed with a low wattage, low energy consumption motor,
your dishwasher washes longer to ensure exceptional cleaning.
Certain models are equipped with an optical water sensor, so
the first cycle will run longer to calibrate to the optical sensor.
Selecting certain options could increase cycle time past 3.5 hours.
Rinse aid is necessary for good drying results. This dishwasher
is designed to be used with rinse aid for good drying performance
and controlling hard water deposit buildup. Energy efficient
dishwashers use less water and energy, so they depend on the
water sheeting action of rinse aid for good drying performance.