Table of Contents
Advertisement
3. SAFETY
THE VENTILATION CONDITIONS WHERE THE PRODUCT WILL BE INSTALLED
AND THE PROTECTION AGAINST FREEZING MUST BE TAKEN INTO
CONSIDERATION.
All the required standard examinations are tested for the product. The predicted
parameters associated with combustion efficiency and exhaust gas emissions are
observed. The stove type described in this manual has been tested according to the
BA 1, DIN 1881 EN13240 standards, by an approved agency.
Combustion chamber cover should be opened only to load the fuel. To avoid
hazards, the combustion chamber must be closed. For the efficient operation of
the stove, there must be minimum of fresh air flow in the room where it is
installed.
CAUTION! The stove can operate in conjunction with the existing multiple
flue systems. This should not be an aspirator, ventilator etc.
The combustion of combustible materials causes heat energy to heat the stove
surfaces (doors, door handles, flame monitor cover, side walls, front wall). These
parts should not be touched without heat-protective gloves.
CAUTION! Since the stove top surface might be hot, please do not put
combustible materials on it.
Hazardous materials (plastic, flammable substances, etc.) may cause chimney fires.
In this case, immediately close all the parts of the stove and call the fire0 fighting.
CAUTION! Check the water level in the stoves and radiators before use.
*** The stove should not be used without water.***
4. INSTALLATION AND CONNECTION
The packaging of the stove protects the product from damage in the best possible
way. However, the stove or its accessories may still be damaged during transport.
Therefore, after removing the stove from the package, check whether it is complete
and undamaged. In case of any damage, notify your dealer.
4
Advertisement
Table of Contents
