sunjoe SPX4003-ELT-RM Owner's Manual page 10

9. Connect the garden hose adapter (female coupler) to
the water inlet of the pressure washer, then thread
your garden hose (male end) into the garden hose
adapter (Figs. 9 – 10). The garden hose must have an
internal diameter of at least 13 mm (1/2 in.) and must be
reinforced. The water supply must be at least equal to the
washer delivery capacity.
NOTE: The machine is not suitable for connection to the
potable water main.
Fig. 9
(FRONT)
Water inlet
(female coupler)
Garden hose adapter
(female coupler)
Garden hose This end to the
(male end) water inlet on
the unit
Fig. 10
(FRONT)
Garden hose adapter
(female coupler)
Garden hose
10. Attach garden hose to water supply (Fig. 11).
Fig. 11
Connect to water supply
Garden hose
m
WARNING!
Do not connect to potable water system.
m
WARNING!
If connection is made to a potable water
system, the system shall be protected against backflow.
m
WARNING!
The intake water temperature must not
exceed 104ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
m
CAUTION!
To prevent damage to the appliance, do not
allow it to operate dry. Before starting the appliance, make
sure that it has proper and stable supply of water.
11. Make sure the ON/OFF switch (pressure select dial) is
pushed to the STOP (0) position before plugging the unit
into the power outlet (Fig. 12).
Fig. 12
10
STOP
0