Table of Contents
Advertisement
7.1.2
Power Management
Status
Power On
Power Saving
Power Off
7.2
Standard Test conditions
Unless otherwise specified, this specification is defined under the following conditions.
(1) Input signal: As defined in Timing table, 1920 x 1080 non-interlaced mode (1920 x 1080 @60Hz), signal
sources must have 75 ohm output impedance.
(2) Luminance setting: controls to be set to 300 nits with full screen 100 % duty cycle white signal
(3) Warm up:
(4) Ambient light:
(5) Ambient temperature:
7.3
Test equipment
Personal computer with Windows 98/2000/XP/VISTA
Luminance meter Minolta CA210
Videogenerator: Chroma 2227, 2230 or equivalent
Colour analyzer: Minolta or Chroma
10 times magnifier
Ruler / Template
Thickness gauge
Watt / Power Meter
7.4
Video Generator test sequence
Will be defined by Innolux or its subcontracted quality providers.
7.5
Analog input
Analog input R,G,B level:
Polarity:
Impedance:
Sync:
7.6
Optical response time
Video Bandwidth:
Response Time
Typical
7.7
Protection circuit
The monitor will not be damaged by:
improper vertical or horizontal sync pulse (picture must be black at improper signals, unsynchronized pictures
are not allowed
H-sy
V-sy
Video
nc
nc
on
on
active
off
on
blanked
on
off
blanked
off
off
blanked
--
--
--
(EE)
more than 30 minutes after power on with signal supplied.
400 – 600 lux.
20 ± 5 qC
205MHz (dot rate)
(CPT)
5ms
)
Power
LED
≤ 58W
Blue
≤0.5W
Blinking Blue
LED
≤ 0.5W
Period: 3sec
On, 3sec Off
≤ 0.5W
≤ 0.5W
Off
0 - 700 mV max.
positive, negative
75 : ± 1%
HV separate sync, composite sync,
231E LCD
Test voltage
90V/60HZ-264V/50Hz
110V/60Hz and 220V/50Hz
110V/60Hz and 220V/50Hz
110V/60Hz and 220V/50Hz
90V/60HZ-264V/50Hz
59
Advertisement
Table of Contents
