Whirlpool W10309054B Use & Care Manual page 20

First try the solutions suggested here or visit our website at www.whirlpool.com/help
If you experience
Load is too hot
Cycle time too short
Is the automatic cycle ending early?
Lint on load
Is the lint screen clogged?
20
for assistance and to possibly avoid a service call.
Possible Causes
Were laundry items removed from
the dryer before the end of the
cycle.
Was a high temperature cycle used,
or was a separate temperature
control set on high.
Solution
Allow the Cool Down cycle to finish before removing laundry
from dryer. All cycles are cooled slowly to reduced wrinkling
and make it easier to handle. Items removed before Cool Down
may feel very warm.
Select a lower temperature, and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the dryness level
setting on Automatic Cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle. If loads are consistently ending
too early, see also Changing the Automatic Dry Default Settings.
Clean lint screen. Check for air movement.