Table of Contents
Advertisement
Cleaning the drain pump
Note: Please read the information in
the Safety → Page 4 and Preventing
material damage → Page 10 sections
to ensure that you use the appliance
safely.
Requirement: The drain pump is
empty. → Page 51
Since water may remain in the
1.
drain pump, remove the pump cap
carefully.
Clean the interior, the thread on
2.
the pump cap and the pump hous-
ing.
Make sure that the impeller in the
3.
drain pump can be rotated.
Insert the maintenance flap and
4.
lock it into place.
Close the maintenance flap.
5.
Cleaning and servicing en
Before the next wash
To prevent unused detergent from
flowing straight into the outlet in the
next wash, run the Udpumpning pro-
gramme after you have emptied the
drain pump.
Turn on the tap.
1.
Insert the mains plug.
2.
Switch on the appliance.
3.
Pour 1 litre of water into the
4.
manual dosing compartment.
Start the Udpumpning pro-
5.
gramme.
18.6 Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
53
Advertisement
Table of Contents
