Make Electrical Connection - Samsung NZ30K6330 Series Installation Manual

Installation instructions
STEP 3-1 Bracket Guide Installing -Main
The bracket Guide can be installed after cooktop is placed into the cutout.
Bottom of Cooktop
M 4 L10
M 4 L16 screw
screw
STEP 3-2 Alternative Bracket Guide Installing
Countertop
UNC 24 3 /
16
L75 screw
M4 X L10
Cooktop
screw
8 English
Radiant Install_NZ30K7570R_DG68-00825A-03_EN+MES+CFR.indb 8
1. Attach bracket guide to bottom of
cooktop and side of wall.
2. Adjust to match hole of bracket and
bottom of cooktop.
3. Tighten screw enough to hold bracket in
place when cooktop is placed in cutout.
4. Using 2 or more people, turn the
cooktop right side up and place in
cutout.
NOTE
Make sure that the front edge of the
cooktop is parallel to the front edge of the
countertop. If repositioning is needed, lift
entire cooktop up from cutout to avoid
scratching the countertop.
1. Attach bracket guide to bottom and
select bracket location.
2. Tighten screw bracket guide to base of
cooktop.
3. Install UNC 24 3 / L75 screw until
16
bracket touches the bottom of the
countertop.

Make electrical connection

This cooktop is manufactured with ground wire (bare or green) connected to the
cooktop frame connect the cooktop cable to the junction box through the UL listed
or CSA approved conduit connector.
Electrical Connection Options
If your home has: And you will be connecting to :
4-wire direct
Afused disconnect or circuit
breaker box
3-wire direct
Afused disconnect or circuit
breaker box
Go to section:
4-Wire Cable from Power
supply to 3-Wire Cable
from Cooktop
3-Wire Cable from Power
supply to 3-Wire Cable
from Cooktop
1/13/2017 3:58:56 PM