Table of Contents
Advertisement
6. Special features
1. STANDBY CAUSE (Page 1/7)
Display of a cause (code) of the last standby.
The cause of the last standby is recorded in EEPROM whenever possible.
Checking this code will be useful in finding a problem when you repair the troubled set.
7. ROM Writing (HDMI_EDID)
1. EDID writing
1) Get ready the PC with COM port (RS-232C) running on Windows 95/98/ME/2000/XP operating system, as well as the RS-232C cross cable.
2) Start the set with the set connected with the personal computer with the RS232C cross cable.
3) Start the terminal software. (The freeware readily available on the Internet will do.)
4) Make the following settings.
Baud rate
: 9600 bps
Data LENGTH
: 8bit
Parity bit
: none
Stop bit
: 1 bit
Flow control
: none
5) Input following commands to terminal software.
"KRSW0001"
PC replies "ERR" (you should ignore this replay)
"KKT10037"
PC replies "OK"
"WRED0000"
PC replies "OK" ... At that time, EDID writing finish with succeess.
6) It usually returns to a state by AC-OFF/ON.
Disconnect and connect AC cable, then TV wakes up with normal mode.
2. Software version
(1) Mainmicon Software
(2) Boot version of mainmicon Software
(3) T-CON Monitor micon Software
*1 Please refer to the change report document for the latest version (Issued it to SEES).
Ver. 1.14 *1
Ver. 1.12 *1
Ver. 1.0
*1
3 – 4
LC-32DH57E/RU/S
Advertisement
Table of Contents
