Amana AGR6603SFB User Instructions page 6

To Set:
1. Push in and turn knob counterclockwise to LITE.
IMPORTANT: All surface burners will click. Only the burner
with the control knob turned to LITE will produce a flame.
2. Turn knob to anywhere between High and Low.
REMEMBER: When range is in use or (on some models)
during the Self-Cleaning cycle, the entire cooktop area may
become hot.
Power Failure
In case of prolonged power failure, the surface burners can be
lit manually. Hold a lit match near a burner, and then turn knob
counterclockwise to LITE. After burner lights, turn knob to setting.
Sealed Surface Burners
A
B
C
A. Burner cap
B. Burner base
C. Alignment pins
IMPORTANT: Do not obstruct the flow of combustion
and ventilation air around the burner grate edges.
Burner Cap: Always keep the burner cap in place when using
a surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.
Alignment: Be sure to align the gas tube opening in the burner
base with the orifice holder on the cooktop and the igniter
electrode with the notch in the burner base.
Gas Tube Opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents, or any other
material to enter the gas tube opening. Keep spillovers out of the
gas tube opening by always using a burner cap.
A
A. 1" to 1
B. Burner ports
Burner Ports: Check burner flames occasionally for proper size
and shape as shown in the previous illustration. A good flame
is blue in color, not yellow. Keep this area free of soil and do not
allow spills, food, cleaning agents, or any other material to enter
the burner ports.
6
E
D
D. Igniter
E. Gas tube opening
B
/ " (2.5 cm to 3.8 cm)
1
2
To Clean:
IMPORTANT: Before cleaning, make sure all controls are OFF
and the cooktop is cool. Do not use oven cleaners, bleach, or
rust removers.
1. Remove the burner cap and the burner base, and clean
according to the "General Cleaning" section.
2. Clean the gas tube opening with a damp cloth.
3. Clean clogged burner ports with a straight pin as shown.
Do not enlarge or distort the port. Do not use a wooden
toothpick. If the burner needs to be adjusted, contact a trained
repair specialist.
4. Replace the burner cap, making sure the alignment pins are
properly aligned with the burner cap.
5. Turn on the burner. If the burner does not light, check cap
alignment. If the burner still does not light, do not service the
sealed burner yourself. Contact a trained repair specialist.
The grates on this range cover the full width of the cooktop. The
2 grates may interlock (on some models), using the hook formed
into 1 end of both grates. The flat end of 1 grate drops onto the
hook on the other grate as shown in the following illustration.
On some models, the 2 grates are identical and can be used on
either the left or right side of the cooktop. Grates that are designed
for use on only 1 side of the cooktop will have either "LEFT" or
"RIGHT" embossed on the bottom side of the grate.
A
B
A. Incorrect
B. Correct
Grates