Timing Of Replacing The Lamp - ViewSonic PJD5122 User Manual

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to
replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a
malfunction in the projector and in some instances the lamp may explode.
CAUTION
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too
hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator
still lights up after turning the power back on, please contact your dealer. See
page 49 for details.
The following lamp warning displays will remind you to change the lamp.
The lamp has been in operation for 3500 hours.
Install a new lamp for optimal performance. If the
projector is normally run with Economic selected
(See "Setting Lamp mode as Economic" on page
44), you may continue to operate the projector
until the 3950 hour lamp warning appears.
The lamp has been in operation for 3950 hours. A
new lamp should be fitted to avoid the
inconvenience when the projector runs out of lamp
time.
The lamp has been in operation for 4000 hours.
It is strongly recommended that you replace the
lamp at this age. The lamp is a consumable item.
The lamp brightness diminishes with use. This is
normal lamp behavior. You can replace the lamp
whenever you notice that the brightness level has
significantly diminished. If the lamp is not
replaced beforehand, it must be replaced after
4000 hours usage.
The lamp MUST be replaced before the projector
will operate normally.
Status
"Indicators" on
Message
Notice
Order Replacement Lamp
Lamp > 3500 Hours
OK
Notice
Replace Lamp Soon
Lamp > 3950 Hours
OK
Notice
Replace Lamp Now
Lamp > 4000 Hours
Lamp usage time exceeded
OK
Notice
Lamp usage time exceeded
Replace lamp (refer to User Manual)
Then reset lamp timer
OK
Maintenance 45