EEC as amended by 92/31/EEC and 93/68/EEC Art. 5 with regard to “Electromagnetic compatibility,” and 73/23/EEC as amended by 93/68/ EEC Art. 13 with regard to “Safety.” User Information for all Countries Notice: Use the cables which are included with the projector or specified. ViewSonic PJ755D...
PS/2, VGA and XGA are registered trademarks of International Business Machines Corporation. Disclaimer: ViewSonic Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from furnishing this material, or the performance or use of this product.
* Use under the following conditions: - In extremely hot, cold or humid environments. - In areas susceptible to excessive dust and dirt. - Near any appliance that generates a strong magnetic field. - Place in direct sunlight. ViewSonic PJ755D...
* Mac compatible Package Overview This projector comes with all the items shown below. Check to make sure your unit is complete. Contact your dealer immediately if anything is missing. PJ755D Projector DVI to D-Sub Cable YPbPr 1.8m Cable1.8m AAA Battery projector.
Main Unit 1 . Focus Ring 2 . Zoom Ring 3 . Zoom Lens 4 . Elevator Button 5 . Elevator Foot 6 . Remote Control Receiver 7 . Connection Ports 8 . Power Socket 9 . Control Panel ViewSonic PJ755D...
To ensure the projector works well with your computer, please set the display mode of your graphic card less than or equal to 1024 X 768 resolution. Make sure the timing of the display mode is compatible with the pro- jector. Refer to the “Compatibility Modes” section on page 26. ViewSonic PJ755D...
4 . Turn on your source (computer, notebook, video player, etc.). The projector will detect your source automatically. * If you connect multiple sources at the same time, use the “ ” Source button on the control panel to switch. * Turn on the pro- jector first and then the signal sources. ViewSonic PJ755D...
* When the “LAMP” indicator flashes red (1 second intervals), it indicates the fan failed. Stop using the projec- tor and disconnect the power cord from the electrical outlet, then contact your local dealer or our service center. See page 23.User Controls ViewSonic PJ755D...
2 . Lower the image, then release the button to lock the elevator foot into position. 3 . Use to fine-tune the display angle.To raise the image: Elevator Button , then release the button to lock the elevator foot Elevator Foot Tilt Addjusting Wheel ViewSonic PJ755D...
16.40' (5.0m) 22.97' (7.0m) 26.25' (8.0m) 32.81' (10.0m) 196.9"(500.0cm) 246.1"(625.0cm) 164.0"(416.7cm) 205.1"(520.8cm) 157.52" x 118.14" 196.88" x 147.66" (400.0 x 300.0cm) (500.0 x 375.0cm) 131.20" x 98.40" 164.08" x 123.06" (333.4 x 250.0cm) (416.6 x 312.5cm) 26.25'(8.0m) 32.81'(10.0m) ViewSonic PJ755D...
Four Directional Select Keys * Use to select items or make adjustments to your selection. Enter * Confirm your selection of items. (Only Analog RGB signal valid) Re-Sync * Automatically synchronizes the projector to the input source. Remote Control ViewSonic PJ755D...
Page 18
* Press “Video” to change source to Composite Video source. * Remark:”*” this is com- puter mode only. And these functions are only available when the projec- tor is connected to a com- puter via an USB cable. ViewSonic PJ755D...
Sub Menu Setting Image - I Image - II Audio Language Management Language Management Image - I Image - II Audio Brightness Contrast Frequency Phase Sharpness Zoom * “Sharpness” func- tion is not sup- ported under computer mode. ViewSonic PJ755D...
Language Management Image - I Image - II Audio Brightness Contrast Color Tint Sharpness Zoom * “Colour” function is not supported under YPbPr source. * “Sharpness” function is not supported under YPbPr and YCbCr source. ViewSonic PJ755D...
DVI-I source. Language Management Image - I Image - II Audio Keystone Press OK to adjust Position Press OK to adjust Colour temp. Display format Advance Press OK to adjust Reset Press OK to reset ViewSonic PJ755D...
Image - I Image - II Audio Volume Treble Bass Stereo/Mono Mute Image - I Image - II Audio Language Management Menu location Projection Lamp Press OK to adjust Source lock Display mode Movie Grame sRGB Dynamic User ViewSonic PJ755D...
Image - I Image - II Audio Language Management Menu location Projection Lamp Press OK to adjust Source lock Display mode Movie Grame sRGB Dynamic User Image - I Image - II Audio Language Management Position Source change Swap ViewSonic PJ755D...
Some Notebook PCs may deactivate their screens when a second display device is in use. Refer to your computerís documentation for information on how to reactivate the monitor display. * If you are using an Apple PowerBook: In Control Panels, open the PowerBook Display to select Video Mirroring “On”. ViewSonic PJ755D...
Page 25
“Replacing the Lamp”. See page 25. Problem: LED lighting message Message Standby State Warning Cooling Normal Error (Lamp failed) Error (Fan failed) Error (Over Temp.) Power LED Temp LED Green Flashing Flashing Lamp LED Flashing Flashing ViewSonic PJ755D...
Page 26
4 . If the problem persists in spite of the above, 5 . please contact a service centre for repair. * Fan Failed: The projector will switch off automatically. please contact a service centre for repair. * Replacing the lamp: Lamp life exceed ViewSonic PJ755D...
Allow it to cool down before changing lamp! Warning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped. ViewSonic PJ755D...
If a product proves to be defective in material or workman- ship during the warranty period, ViewSonic will at its sole option repair or replace the product with a like product. Replacement product or parts may include remanufac- tured or refurbished parts or components.
Page 31
Sales outside the U.S.A. and Canada: For warranty information and service on ViewSonic products sold outside of the U.S.A. and Canada, contact ViewSonic or your local ViewSonic dealer. Projector Warranty (V3.1)
Need help?
Do you have a question about the PJ755D and is the answer not in the manual?
Questions and answers