Aquasensor; Sensors; Autoopen Dry; Installation And Connection - Siemens iq500 SN85EX69CG User Manual

en Installation and connection

AquaSensor

The AquaSensor is an optical meas-
uring device (light barrier) which
measures the turbidity of the rinsing
water. You can save water with the
AquaSensor.
Use of the AquaSensor depends on
the programme. If the soiling level is
high, the rinsing water is drained off
and replaced with fresh water. If the
soiling level is lower, the rinsing wa-
ter is used in the next wash cycle, so
reducing water consumption by 3-6
litres. In the automatic programmes
the temperature and run time are ad-
ditionally adjusted to the level of soil-
ing.

Sensors

The sensors adjust the programme
sequence and strength in the auto-
matic programmes depending on the
level and type of soiling.
The sensor has different sensitivity
settings that can be changed in the
basic settings.
Sensor setting
SE:00
SE:01
SE:02
12
Description
Optimum setting for a
mixed load and heavily
soiled tableware. Saves
both energy and water.
Adjusts the programme
strength for effective re-
moval of food remnants
even with low soiling
levels. Energy and water
consumption are adjusted
accordingly.
Adjusts the programme
strength for difficult condi-
tions of use, e.g. stubborn
dried-on food remnants.
Recommended setting
when using organic or eco-
logical detergents contain-
Sensor setting

autoOpen Dry

The appliance door opens automatic-
ally during the drying phase. This en-
sures a particularly economical dry-
ing result.
For best drying results wait until the
end of programme before unloading
the tableware. The programme has
ended when the display shows
"00h:00m".
If the automatic door opening is de-
activated, energy consumption in-
creases and the drying phase is usu-
ally reduced.
→ "Overview of basic settings",
Page 36

Installation and connection

Installation and connec-
tion
Installation and connection

Scope of supply

After unpacking all parts, check for
any damage in transit and complete-
ness of the delivery.
If you have any complaints, contact
the dealer who sold you the appli-
ance or our Customer Service.
Note: The appliance has been tested
at the factory to check it is in working
order. It is possible that water has left
marks on the appliance. These
marks will disappear after the first
wash cycle.
The delivery consists of the following:
¡ Dishwasher
¡ Operating instructions
¡ Installation Instructions
Description
ing low levels of active
agents. Energy and water
consumption are adjusted
accordingly.