Download Print this page

Non-Active Pixels; Installing And Removing The Stand - Hisense LHD32V77MH User Manual

Hospitality lcd television

Advertisement

Installing and removing the stand

Cautions
Damage requiring service
Unplug this TV from the power outl
service personnel under the following conditions:
When the power supply cord or plug is damaged or frayed.
If liquid has been spilled or objects have fallen into your TV.
If your TV has been exposed to rain or water.
If your TV does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions because incorrect adjustment of other
controls may result in damage and will often require extensive
operation.
If your TV has been dropped or damaged in any way.
When your TV exhibits a distinct change in performance.
Outdoor antenna grounding
If an outside antenna or cable system is connected to your TV, make sure
that the antenna or cable system is grounded to provide some
protection against voltage surges and built-up static charges. Article
810 of the National Electrical Code, ANSI/NFPA No. 70, provides
information with respect to correct grounding of the mast and
supporting structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location of the
antenna-discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode.
7
Antenna lead-in wire
1
Grounding clamp
2
Antenna discharge unit
3
Grounding conductors
4
Ground clamps
5
Power service grounding electrode
6
system
Electric service equipment
7
Note to CATV system installer
Article 820 of the National Electrical Code, ANSI/NFPA No. 40 provides
ground must be connected to the grounding system of the building as
close to the point of cable entry as practical.
Condensation
Moisture will form on the TV if the TV is brought from cool surroundings
into a warm room or if the temperature of the room rises suddenly.
When this happens, the TV's performance may be impaired. To prevent
this, let the TV stand in its new surroundings for about an hour before
switching it on, or make sure that the room temperature rises gradually.
nician to restore your TV to its normal
1
2
3
4
5
6
it states that the cable
Condensation may also form during the summer if the TV is exposed to
the breeze from an air conditioner. In such cases, change the location of
the TV.
Mobile telephone warning
To avoid interference with your TV picture and sound, operating
problems, or even damage, keep your cordless and cellular telephones
away from the TV.
End of life directives
small amount of mercury. Disposal of these materials may be regulated
for environmental reasons. Your TV also contains material that can be
recycled and reused. For disposal or recycling information, contact your
local authorities or the Electronic Industries Alliance at www.eia.org to

Non-active pixels

provide exceptionally sharp video quality. Occasionally, a few
of your TV, and are not considered defects.
Accessories
Make sure the following accessories are included in the box with your
TV:
Remote control
AC power cord
AAA batteries (2)
Stand
Quick Setup Guide
Installing and removing the
stand
You must install your TV into the stand in order for it to stand upright on
or other vertical surface, you must remove the stand .
Warning: Before attampting assembly or removal of the stand, unplug
the AC power cord.
Cautions:
Read these instructions carefully before you try to assemble the stand
or remove the stand .
Make sure that you handle the TV carefully when attempting to
assemble or remove the stand. If you are not sure of your ability to do
this, contact a professional installer or service technician. Hisense is
not responsible for any damages or injuries that occur because of
mishandling or incorrect assembly.
Use a soft cushion or covering to prevent scratching or damage to the
TV screen or cabinet.
Installing the stand
Note
To install the stand:
1 Remove the stand from the box and place it on a table or bench.
LHD32V77MH
3

Advertisement

loading