Using The Display; Setting The Timing Mode; Osd And Power Lock Settings - ViewSonic VA2261-6 User Manual

Using the Display

Setting the Timing Mode

Setting the timing mode is important for maximizing the quality of the screen image
and minimizing eye strain. The timing mode consists of the resolution (example
1024 x 768) and refresh rate (or vertical frequency; example 60 Hz). After setting
the timing mode, use the OSD (On-screen Display) controls to adjust the screen
image.
For optimal picture quality, please use the recommended timing mode specific to
your display listed on the "Specification" page.
To set the Timing Mode:
• Setting the resolution: Access "Appearance and Personalization" from the
Control Panel via the Start Menu, and set the resolution.
• Setting the refresh rate: See your graphics card's user guide for instructions.
IMPORTANT: Please make sure that your graphics card is set to 60Hz vertical
refresh rate as the recommended setting for most displays.
supported timing mode setting may result in no image being displayed, and a
message showing "Out of Range" will appear on screen.

OSD and Power Lock Settings

• OSD Lock: Press and hold [MENU] and the up arrow
other buttons are pressed the message OSD Locked will display for 3 seconds.
• OSD Unlock: Press and hold [MENU] and the up arrow
• Power Button Lock: Press and hold [AUTO] and the down arrow
seconds. If the power button is pressed the message Power Button Locked
will display for 3 seconds.
display's power will automatically turn ON when power is restored.
• Power Button Unlock: Press and hold [AUTO] and the down arrow
10 seconds.
With or without this setting, after a power failure, your
6
Choosing a non-
for 10 seconds. If any
again for 10 seconds.
for 10
again for