Assembling The Surface Burners; Checking Ignition Of The Surface Burners - LG LRGL5823SLG Owner's Manual

Assembling the Surface
Burners
CAUTION
Do not operate the burners without all parts in place.
Place the burner caps and heads on the cooktop.
Make sure that the caps and heads are placed in the
correct locations. There is one small, one medium,
one large, and one extra large burner head and cap.
Center Burner
Oval (Center) burner
head/cap assembly
Medium
burner
head
and cap
Front of range
Large burner
head and cap
Hole
Electrode
Make sure the hole in the burner head is positioned
over the electrode.
Checking Ignition of the
Surface Burners
Electric Ignition
Select a surface burner knob and simultaneously
push in and turn to the Lite position. You will hear
a clicking sound indicating proper operation of the
spark module.
Once the air has been purged from the supply lines
the burner should ignite within 4 seconds. After the
burner ignites, rotate the knob out of the Lite position.
Try each burner in succession until all burners have
been checked.
Quality of Flames
The combustion quality of the burner flames needs to
be confirmed visually.
• With LP gas, some yellow tipping on outer
Small burner
Adjusting the Surface Burner to the
head and
cap
Low Flame (Simmer) Setting
1
2
Extra large burner
head and cap
3
4
Hole
Electrode
Hold the valve shaft with one hand while turning
the screw to adjust with the other.
5
6
7
A Yellow flames - Call for service.
B Yellow tips on outer cones - This
is normal for LP gas.
C Soft blue flames - This is normal
for natural gas.
NOTE
cones is normal.
Light all surface burners.
Turn the knob on the burner being adjusted to
Lo.
Remove the knob.
Insert a small, flat-blade screwdriver with a
minimum length of 3" (76.2 mm) and a diameter
of / " (2.4 mm) into the valve shaft.
3
32
Valve shaft
Center adjustment screw
NOTE
Replace the knob.
Test the flame stability.
Test 1: Turn the knob from Hi to Lo quickly. If the
flame goes out, increase the flame size and test
again.
Test 2: With the burner on a Lo setting, open
and close the oven door quickly. If the flame is
extinguished by the air currents created by the
door movement, increase the flame height and
test again.
Repeat steps 1-6 for each surface burner.
INSTALLATION 19