Preparation - Fujitsu ABT14RG Operating Manual

PREPARATION

Turn on the Power
Connect the power supply plug to an electrical outlet; in the
case of a direct line connection, turn on the circuit breaker.
Load Batteries (R03/LR03 × × × × × 4)
1
Slide the battery compartment lid to open it.
2
Insert batteries.
Be sure to align the battery polarities (
3 Close the battery compartment lid.
Set the Current time
1 Press the TIME ADJUST button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the (
the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3 Press the TIME ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
G The remote control unit must be pointed at signal receiver to operate correctly.
G Operating range: About 7 meters.
G When a signal is properly received by the air conditioner, a beeping sound will
be heard.
G If no beep is heard, press the remote control unit button again.
Remote Control Unit Holder
For use as Handy Type
Insert
Screws
1 Mount the Holder. 2 Set the Remote
Control Unit.
6
)SET TIME buttons to adjust the clock to
Slide up
3 To remove the
Remote Control
Unit (when use at
hand).
) correctly.
For use as Wall Fixing Type
Screws
1 Mount the Holder.
CAUTION!
G Take care to prevent infants from
accidentally swallowing batteries.
G When not using the remote control unit
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
G If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
G Dead batteries should be removed
immediately and disposed of properly,
either in a battery collection receptacle
or to the appropriate authority.
G Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the remote control
unit's operating range becomes appre-
ciably reduced, replace the batteries and
press the ACL button with the tip of a
ballpoint pen or other small object.
SET
SET SWING
TIME
ENERGY
ADJUST
SAVE
Insert
Screw
2 Set the Remote 3 Attach the unit to
Control Unit. the holder as
shown.
SWING
TEST
RUN ACL
Slide