LG LTUC186ELE1 Owner's Manual page 21

Auto Operation Mode (Cooling model)
1
Press the On/Off Button.
2
To select Auto Operation, press the Operation Mode Selection button.
Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
COOLING MODEL
Operation Display
AUTO SWING OPERATION
Timer Operation unit
On Off
Set no. Time 01 03 05
Cooling Operation
3
The temperature and fan speed are automatically set by the electronic controls based on the actual
room temperature. If you want to change the set temperature, close the door on the remote control
and press the Room Temperature Setting buttons. The cooler or warmer you feel, the more times
(up to two times) you should press the button. The set temperature will then be changed.
The temperature can be set within a range of -2~2 by 1 level.
AUTO SWING OPERATION
Operation unit
Timer
On Off
Set no. Time 01 03 05
(This indication will be shifted to the initial
Auto Mode Display state after 5 seconds.)
During Auto Operation:
❏ You cannot switch the indoor fan speed. It has already been set by the Fuzzy rule.
❏ If the system is not operating as desired, manually switch to another mode. The system will not
automatically switch from the cooling mode to the heating mode, or from heating to cooling, it must be
done by manually resetting.
❏ During Auto Operation, pressing the auto swing button makes the horizontal louvers swing up and
down automatically. If you want to stop auto-swing, press the auto swing button again.
SET TEMP FAN SPEED SUB FUNCTION AUTO SWING
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Program set Timer Operation unit
On Off
07 09 11 13 15 17 19 21 23 Set no. Time 01
Soft Dry Operation
SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
1 2 3 4
Time ZONE
Program set
07 09 11 13 15 17 19 21 23
OPERATION SET TEMP FAN SPEED SUB FUNCTION AUTO SWING
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Program set Timer
On
03 05 07 09 11 13 15 17 19 21 23 Set no. Time
Cold Cool Proper Warm Hot
To increase the Temperature.
To decrease the Temperature.
Operating Instructions
OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Operation unit Program set
Off
01 03 05 07 09 11 13 15 17 19 21 23
Auto Operation
Owner's Manual 21