Assembling The Debris Shield (Fig. 4); Adjusting The Harness; Fuel And Lubrication; Fuel - VARO PowerPlus Garden POW60478 Manual

 Fit the upper plate (F) and adapter housing € to the output Axle.

Turn the blade axle until one of the holes in the upper plate aligns with the hole in the gear
housing (H).

Insert a lock pin in the hole (H) so that the axle is locked. Place the blade (D), low plate
(C) and plate housing (B) on the output shaft. Fit the nut (A). Use the socket spanner in
the tool kit. Hold the handle of the spanner as close to the blade guard as possible. The
nut is tightened when the spanner is turned against the direction of rotation (left-hand
thread).
Attention! During your work with the cutting device always wear work
gloves in order to avoid cutting injuries.
Attention! Use only metal cutting blades, which are not damaged or twisted.
The cutting blade may be removed in the opposite sequence.
Attention! The cutting blade's drill hole diameter must exactly match the
turntable diameter.
7.5

Assembling the debris shield (Fig. 4)


Fasten the cord cutter (A) to the shield (C) with a ST3.5x12 screw as shown.

Attach the shield extension (B) to the shield bottom.
7.6

Adjusting the harness


On the front is an easily accessible, quick release latch.

Pull out the red strap.

The hip strap and one shoulder strap will be automatically released at the same time.

8 FUEL AND LUBRICATION

8.1

Fuel

Use unleaded gas mixed with 2-cycle engine oil in the ratio 40:1. It will guarantee the unit's
optimum performance.
Caution! Do not ever use pure gasoline in your unit. It could permanently
damage the engine and exclude warranty claims concerning this product.
Never use a fuel mixture, which has been stored for more than 90 days.
Caution! Use only first class 2-cycle oil mixed in the ratio 40:1. Do not use
2- cycle oil with the recommended mixing ratio 100:1. In case of damage
caused by insufficient lubrication no warranty claims will be possible.
8.1.1

Mixture of gasoline and oil in the ratio 40:1

First of all, pour oil into the fuel tank and than add gasoline in order to mix it with the oil. Shake
the tank properly in order to reach a good mixture.
Caution! Insufficient lubrication excludes warranty claims. Gasoline and oil
must be mixed in the ratio 40:1.
Copyright © 2015 VARO
POW60478
P a g e | 6
EN
www.varo.com