Petrol Safety Warnings; Assembly; Two-Handed Fork Handle; Mounting Of The Protective Cover (Fig. 1) - VARO PowerPlus Garden POW60478 Manual


DO NOT ADD, REMOVE OR ALTER ANY COMPONENTS OF THIS PRODUCT. Doing
so could cause personal injury and/or damage the unit, and void the manufacturer's
warranty.

DO NOT operate your unit near or around inflammable liquids or gases whether in or out
of doors. An explosion and/or fire may result.

DO NOT USE ANY OTHER CUTTING ATTACHMENT. Only use our replacement parts
and accessories, which are designed specifically to enhance the performance and
maximize the safe operation of our products. Failure to do so may cause poor
performance and possible injury. Use only the stringhead supplied with this product. Do
not use any other cutting attachment. Use of such attachments will void your factory
warranty and may result in serious bodily injury.

6 PETROL SAFETY WARNINGS

WARNING: Use extra care when handling fuels. They are inflammable and
the vapours are potentially explosive. The following points must be
observed.

Use only an approved container.

Never remove the fuel cap or add fuel when the engine is running. Allow engine exhaust
components to cool before refueling.

Do not smoke.

Never refuel the machine indoors.

Never store the machine or fuel containers in places where there is a naked flame, such
as a water heater.

If fuel is spilt, do not attempt to start the power source before moving the machine away
from the spillage area.

Always replace and securely tighten the fuel cap after refueling.

Whenever the tank is drained, this should be done outdoors.

7 ASSEMBLY

7.1

Two-handed fork handle


Loosen the handle screws and place the handle into the holder, as depicted in the main
figure.

Re-tighten the screws and verify they are properly tightened.
Warning: Make sure the grip is properly mounted and check it regularly.
Parts, which are not properly mounted, represent a risk of injury.
7.2

Mounting of the protective cover (Fig. 1)


Assemble protective cover as fig. 1 illustrates, note that the bolts should be tightened.

Fig. 1: 4pcs 5x20mm bolts (A), 4pcs 5mm washers (B), spacer plate (C).
7.3

Trimmer mounting (Fig. 2)


Fit the upper plate (D) and adapter housing © to the output axle.

Turn the blade axle until one of the holes in the upper plate aligns with the hole (F) in the
gear housing (E).

Insert a locking pin in the hole (F) so that the axle is locked.

Place the low plate (B) and nylon trimmer head (A) on the output shaft.

Screw on the trimmer head (A) in the direction of rotation.
7.4

Cutting blade mounting (Fig. 3)

Copyright © 2015 VARO
POW60478
P a g e | 5
EN
www.varo.com