Table of Contents
Advertisement
ELECTRICAL CONNECTION
•
It is the installer's complete responsibility to comply with installation clearances specified in
the manual. The Minimum Cabinet opening dimensions/clearances shown must be used. The
minimum spacings must be maintained between the appliance cooking surface and the horizontal
surface above the cooking top.
•
30 inches (65cm) is the minimum clearance between the top of the cooking surface and the bottom
of an unprotected wood or metal cabinet
•
To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage locat-ed
above the cooktop surface should be avoided. If cabinet storage is to be provided, the risk can be
reduced by installing a range hood that projects horizontally a minimum of 5 inches beyond the
bottom of the cabinets.
•
To level your electric range, adjust the leveling legs at the bottom of the unit.
•
Avoid locating the unit in moist areas as this may result in the risk of electrical shock.
•
The range may only be connected using the certified Power Cord and Plug supplied with this
Electric Range. This range is equipped with a CSA International Certified Power Cord intended to
be plugged into a standard 14-50R wall receptacle. Be sure the wall receptacle is within reach of
range's final location.
•
The range must be connected to the proper electrical voltage and frequency as specified on
the rating la bel.
•
For personal safety, the range must be properly grounded.
•
Disconnect ALL Power to the Electric Range at the electrical panel before beginning installation.
•
Do not attempt to repair or replace any part of the appliance unless it is specifically recom-
mended in this manual. All other servicing should be referred to a qualified technician.
• To minimize the possibility of electric shock, disconnect this appliance from Power Supply be-fore
attempting any Service, Cleaning or Maintenance
NOTE: Turning the appliance off does not disconnect the appliance from power supply. Only a
qualified Service Technician should service your appliance
WARNING: Improper grounding can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized Service Centre or Certified Electrician
It is recommended that the power cord and plug be
place parallel with the floor so that the cord runs
parallel with the floor.
Installation Instructions
Advertisement
Table of Contents
