Transporting Your Refrigerator (Transport For Moving) - Hitachi R-E6200S How To Use Manual

Peel off the seal from the Antioxidation Fresh Cassette in the Vacuum Compartment.
4
Peel off the seal from the Antioxidation Fresh Cassette set in front
of the Vacuum Compartment before use.
● Antioxidant constituent and hot flavor will not be released until the seal is peeled off.
Caution
he
e
5
Plug the power cord.
It is not a problem to plug in the power cord soon after installing the refrigerator.
Use a wall outlet exclusively when connecting the power cord. (Alternating current 220 - 240V, rated 10A or more)
● Check that the power plug or the cord is not wedged between the back of the refrigerator and the wall in order to prevent the cord from getting hot.
Cooling inside the refrigerator starts.
● It may take more than 4 hours to cool well the inside of the refrigerator, depending on conditions such as the ambient
● Perform "Ice Maker Cleaning" when using the automatic ice making function for the first time.
● A series of ice making operation will start automatically after the inside of the refrigerator is cooled well.
Notice
Caution

Transporting your refrigerator (transport for moving)

1
Take out foods or ice.
2
Pour off the water from the water
supply container/ice tray.
3
Pull off the power plug.
No problem just before moving.
4
Remove the leg covers, and raise the
adjustable mounts.
5
Use a tape to secure the door/power
cord.
6
Place a sheet or cloth for protection
when moving / transporting it.
To prevent damage to the floor material or water from spilling out.
BB0040171R_R-E6200SHV_B.indd 43
● Do not wash it in water.
● Do not smell it directly. It may be irritating to the nose.
temperature or storage state of foods. It may take 24 hours or more in summer, etc.
Do not put ice cream, uncooled foods or perishable foods in it until the inside of the refrigerator is cooled well.
(When using for the first time, it may take 24 hours and more to make ice.)
● After the power plug is inserted, the cool air flap continues to work for about 2 minutes to check the state of the cool
air flap (it may sound louder than usual, but it is normal).
● It may smell of plastics in the beginning when you start to use. Keep the room well-ventilated. Such smell will
disappear gradually.
● If you wish to install the refrigerator in a hot spring area exposed to sulfide gas, you
may need to apply anti-rust treatment to the piping. Contact your dealer in advance.
Failure caused by sulfide gas will not be covered under guarantee.
● Do not peel off the seal on the back or plastics at the lower part of the side.
● When a magnet or suction cup is attached on the side of the body or the surface of a door, it
may leave a mark.
Pull it out right above.
Place a sheet or cloth
7
for protection first, and
then lay it back to drain
water.
Such as old cloth
8
Make sure to hold the
handles when carrying it
with 2 persons or more.
Do not lay it down horizontally for
transportation (which may cause failure
of the refrigerator).
9
See " Preparation before use " for
installing the refrigerator in a new
location.
Pg.42
Peel off the seal, and then return it back.
Pg.58
Stickers
Plastic parts - Left/Right
43
15.5.25 3:31:06 PM