Table of Contents
Advertisement
Installation Instructions
Suitable Installation Place
Solid and level floor
• Unstable installation causes vibration and noise of
refrigerator.
• Wooden floor or carpet can be discolored under the
refrigerator.
• Doors look hanged down due to the twist of
refrigerator unless it is leveled.
Shady and humid place
• Direct sun rays, side heat of stove and gas range can
weaken the refrigerating power.
• Avoid location by a sink or where moisture and water
can cause rust and corrosion.
• Avoid location where moisture can cause electrical
problems.
• Use hard board or plank on the concrete/cement floor.
Installation of the Appliance
The space required for installing the appliance is
shown below. (unit: mm)
• More than 10cm from 3 sides(lieft, right, and back) is
good enough for ventilation.
• Insufficient space causes the noise of vibration,
weakening of refrigerating power and the waste of
electricity.
595
921
Grounding
Grounding terminal is the green one connected to the
power cord in the back of refrigerator.
Grounding is necessary at
the place where water splashes easily;
humid basement;
any wet or watery place.
Grounding with grounding wire
Copper plate connected with ground wire is to be buried
25cm deep in the ground.
100
100
Wall
Grounding with short-circuit breaker
Short-circuit breaker is necessary in wet floor like fish
shop, kitchen of restaurant and etc...
Grounding is not necessary
in case of using side-grounded outlet.
Don't connect the ground wire to
water pipe, gas pipe, telephone line or lightening-rod due
to the possibility of explosion or fire.
Correct usage of Refrigerator
Plug in the refrigerator right after installation.
• Once the refregerator is plugged in, make sure the
interior light comes on when you open the doors.
Set the temperature of both compartment to "MAX" to
conduct the preparatory run for 2 or 3 hours.
Once inside of refrigerator is cooled enough, then
put the food in the refrigerator.
* When ambient temperature is high in midsummer,
do not open and shut the doors frequently after
installation.
Installation of height adjustment feet for
leveling
Level refrigerator to rest solidly on the floor.
There are two leveling feets under each front corner
of refrigerator.
Turn leveling feet clockwise to raise the refrigerator
and turn it counter-clockwise to lower.
Use shims under the rear corners if necessary.
• If you want the door of refrigerator to be closed
smoothly and not to be open easily, adjust the front
feets to be raised horizontally.
3
Advertisement
Table of Contents
