LG DR389-W Manual page 15

DR389-W_BZAFLLS 2/1/08 11:11 AM
Sampling Freq. (Frequency) – Selects the sampling frequency of the audio
signal.
[48 kHz]: In case of DVD with 96KHz sampling, Output is converted to
48kHz. If your receiver or amplifier is NOT capable of handling 96 kHz sig-
nals, select [48 kHz].
[96 kHz]: The digital audio signals are output in their original sampling format.
DRC (Dynamic Range Control) – Make the sound clear when the volume is
turned down (Dolby Digital only). Set to [On] for this effect.
Vocal – Select [On] to mix karaoke channels into normal stereo. This function is
effective for multi-channel karaoke DVDs only.
Adjust the lock settings
To access the Rating, Password or Area Code options, you must enter the 4-
digit password. If you have not yet entered a password you are prompted to do
so. Enter a 4-digit password. Enter it again to verify. If you make a mistake
while entering number, press CLEAR repeatedly to delete numbers one by one
then correct it.
If you forget your password, you can reset it. Displays the SETUP menu. Input
'210499' and select [OK] to confirm. The password has now been cleared.
Rating – Select a rating level. The lower the level, the stricter the rating. Select
[No Limit] to deactivate the rating.
Set Password – Changes or deletes the password.
[Change]: Enter the new password twice after entering the current password.
[Delete]: Delete the current password after entering the current password.
Area code – Select a code for a geographic area as the playback rating level.
This determines which area's standards are used to rate DVDs controlled by the
parental lock. See the Area Codes on page 28.
Page 15
Adjust the recording settings
Disc Record Mode – Select the picture quality for recording from XP, SP, LP,
EP or MLP. See recording time of each mode on page 30.
[XP]: Highest picture quality.
[SP]: Standard picture quality.
[LP]: Slightly lower picture quality than [SP] mode.
[EP]: Low picture quality.
[MLP]: The longest recording time with the lowest picture quality.
DV Record Audio – You need to set this if you have a camcorder using
32kHz/12-bit sound connected to the front panel DV IN jack.
Some digital camcorders have two stereo tracks for audio. One is recorded at
the time of shooting; the other is for overdubbing after shooting.
On the Audio 1 setting, the sound that was recorded while shooting is used.
On the Audio 2 setting, the overdubbed sound is used.
Auto Chapter – When DVD recording, chapter markers are added automatical-
ly in every specified interval (5 or 10 min.).
If you select None, switch off automatic chapter marking altogether with the No
Separation setting.
15