Table of Contents
Advertisement
Operations
Turning the power on and off
Connecting the power cord
Insert the power cord connector
1
into the AC IN socket of the
projector.
2
Insert the power cord plug into a
wall or other power outlet.
Removing the lens cap
Be sure to remove the lens cap when the power is turned on. If the cap is left on the
projector, it could become deformed due to heat.
Turning the power on
Turn on the main power switch.
1
The ON/STANDBY indicator will change to orange,
indicating standby mode.
Press the ON/STANDBY button.
2
The power turns on with a beep sound (if the beep
sound is set to [On]), and the ON/STANDBY indicator
lights green. After a moment, the start-up screen
appears.
CAUTION
•
Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyesight.
•
Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.
•
Do not place your hands, face, or other objects near the air exhaust, the lamp cover or
the bottom of the unit. Doing so could result in injury and/or damage the object.
Power cord connector
(Supplied)
Remote
Control panel
control
24
Notes
•
The start-up screen will disappear after a moment. You can dismiss the start-up screen
before this by performing any operation. You can also configure the system to prevent
the start-up screen from appearing. To do this, use the Display setting menu
•
The first time you use the projector after purchase, after the start-up screen disappears,
the start menu is displayed
.
p.26
•
You can disable the beep sound in the Default setting 1 menu
•
When [Key lock] is [On], the operation buttons of the projector do not work
•
When [Password] is [On], enter password then the start-up screen is displayed after the
Password entry screen disappears
p.33
•
Do not touch the lens directly with your hand.
If fingerprints or stains are left on the projection lens surface, they may interfere with the
projector's ability to project images on the screen.
Turning the power off
Press the ON/STANDBY button.
1
When the setting of beep sound is [On], the projector beeps, and a message appears
on the screen, confirming that you wish to shut off the power. To shut off the power,
press the ON/STANDBY button again. If you do not wish to shut off the power, wait for a
while without conducting any operations. This message will disappear after a moment.
(This operation is no longer valid after the message disappears.)
2
Press the ON/STANDBY button again.
When the setting of beep sound is [On], the projector beeps, and the screen
disappears, but the internal cooling fan continues to operate. Then, the projector goes
into standby mode.
During cooling, the ON/STANDBY indicator flashes. While the
indicator is flashing, the power can not be turned back on. There is
no problem with unplugging the power cord in this state.
3
Turn off the main power switch.
4
Replace the lens cap.
After use, replace the lens cap.
Note
•
The projector consumes about 11 W of power in
standby. We recommend that you unplug the power cord
if you will not be using the projector for an extended
period.
Precautions
•
When you wish to restart the projector again right after turning off the power, give the
lamp time (about 5 minutes) to cool before plugging it back in. If the lamp overheats, it
may fail to light.
•
Right after turning off the power, the unit may become very hot, especially air exhaust,
lamp cover or the bottom of the unit. Please handle with care to avoid burn injuries.
p.38
.
p.41
p.43
.
25
.
.
Advertisement
Table of Contents
