Picture Id Settings - LG 32LS53A Owner's Manual

28
ENTERTAINMENT

Picture ID Settings

Picture ID is used to change the settings of a
specific set (display) using a single IR receiver
for multi-vision. Communication is possible
between a monitor with an IR receiver and
other monitors using RS232C cables. Each
monitor is identified by a Set ID. If you assign
the Picture ID using the remote control, only
AUDIO
displays with matching Picture ID and Set ID
(RGB/DVI)
RS-232C OUT
can be controlled remotely.
RS-232C IN
REMOTE
CONTROL IN
1.
Assign the Set ID to the installed monitors as
.
shown below
IR & Light Sensor
RS232C cables
2
. Press the red ON button on the remote
control to assign the PICTURE ID.
RS-232C OUT RS-232C OUT
RS-232C IN RS-232C IN
PICTURE ID ON [2]
3.
Assign the Set ID to the selection of your
choice.
A set with a different Set ID from the Picture
•
ID cannot be controlled by IR signals.
NOTE
If Picture ID is set to 2, only the upper right
•
monitor, which has a Set ID of 2, can be
controlled by IR signals.
If you press the green OFF button for
•
PICTURE ID, the Picture IDs for all
monitors are turned off. If you then press
any button on the remote control, all
monitors can be controlled by IR signals
regardless of Set ID.
With PICTURE ID ON, you can only
•
increase the picture ID by 1. You cannot
decrease it.