Table of Contents
Advertisement
Installation and Setup
TV Connection
Make one of the following connections, depending on
the capabilities of your existing equipment.
Tips:
Depending on your TV and other equipment you
wish to connect, there are various ways you could
connect the DVD/CD Receiver. Use one of the
connections described below.
Please refer to the manuals of your TV, VCR,
Stereo System or other devices as necessary to
make the best connections.
Caution:
Make sure the DVD/CD Receiver is connected
directly to the TV. Select the correct AV input on
your TV.
Do not connect your DVD/CD Receiver to TV via
your VCR. The DVD image could be distorted by
the copy protection system.
Rear of DVD/CD Receiver
INPUT
MONITOR
L - AUX - R
Y
COMPONENT VIDEO (PROGRESSIVE SCAN)
OUT PUT
V
C
VIDEO
COMPONENT VIDEO /
INPUT
PROGRESSIVE SCAN INPUT
Y
L
Rear of TV
Video connection
Connect the MONITOR OUT jack from the DVD/CD
Receiver to the VIDEO IN jack on the TV using the
video cable (V).
Component Video connection
Connect the COMPONENT VIDEO OUT jacks from
the DVD/CD Receiver to the corresponding jacks on
the TV using an Y P
If your television is a high-definition or "digital
ready" television, you may take advantage of the
DVD/CD Receiver's progressive scan output for the
highest video resolution.
If your TV does not accept your resolution setting,
abnormal picture appears on the screen. Please
read owner's manual for TV then set the resolution
that your TV can accept.
Note:
The HDMI mode must be set to OFF for VIDEO OUT
and Component video connections.
HDMI OUT
HDMI OUT
P
cable (C).
B
R
7
Advertisement
Table of Contents
