Advertisement
E
Tips for best results
•
Always hold the shaver at right angles to the skin so that all foils are
touching the skin with equal pressure.
•
Use moderate to slow stroking movements. The use of short linear motions
in stubborn areas may obtain a closer shave, especially along the neck and
chin line.
•
DO NOT press hard against the skin in order to avoid irritation and damage
to the foil heads.
C CLEANING AND MAINTENANCE
, DRY CLEANING
•
Remove the foil assembly by pressing the foil assembly release buttons on
both sides of the head and lifting the assembly upwards from the hair
pocket
•
Gently tap out the excess hair shavings and use a cleaning brush to clean
out the hair pocket if necessary.
•
Do not use a brush to clean the shaving foils.
•
Replace the head assembly.
, REPLACING THE FOILS & CUTTERS
•
To ensure continued high quality performance from your shaver, we
recommend the foils and cutters are replaced regularly.
, Signs that your foil/s and cutter/s need replacing
•
Irritation: as foils get worn, you may experience skin irritation.
•
Pulling: as the cutters wear, your shave may not feel as close and you may
feel the cutter pulling your hair.
•
Wear through: you may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
•
Remove the foil assembly by pressing the foil assembly release buttons on
both sides of the head and lifting the assembly upwards from the hair
pocket.
•
Insert the new foil assembly on the hair pocket, press down and click into
place.
, REPLACING THE CUTTERS
•
Grasp the cutter between your thumb and forefinger and pull upwards.
•
Snap the new cutter into the oscillator tip.
, Note: DO NOT press on the cutter ends as this may cause damage.
•
Foil and cutters replacement model: SP62
5
Advertisement
