Preparation Of The Remote Control - Toshiba SD-P2900SR Owner's Manual

Preparation of the remote control

Insert the specifi ed battery to the remote control. See
page 8 ,
for safety use of coin-shaped batteries.
9
Gently insert a fi ngernail in groove q
1
and pull out the holder in direction w.
Backside
Take care not to break your fi ngernail.
Place a coin-shaped
2
battery (CR2025) with the
side up on the holder.
＋
Keep the holder horizontal so that
the battery does not fall through.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or
equivalent type.
3 Insert the holder into the remote control.
The remote control battery contains Perchlorate
Material - special handling may apply. See
www.dtsc.ca.gov/ hazardouswaste/perchlorate
26
1
2
Operating with the remote control
Point the remote control at the remote sensor and press
the buttons.
Distance: About 3 m (9.9 feet) from the front of the remote
sensor
Angle: About 30° in horizontal direction of the front of the
remote sensor
Do not expose the remote sensor of the player to a strong light
source such as direct sunlight or other illumination. If you do
so, you may not be able to operate the player via the remote
control.
・ Aim the remote control at the remote sensor of the player.
・ Do not drop or give the remote control a shock.
・ Do not leave the remote control near an extremely hot or humid place.
・ Do not spill water or put anything wet on the remote control.
・ Do not disassemble the remote control.
・ If the remote control does not function correctly or if the operating
range becomes reduced, replace the battery with new one.
・ Inserting a battery other than the specifi ed one or an object may
damage the remote control.
Within about 3 m (9.9 feet)