LG F1422TD1 Owner's Manual page 18

H ow to use washer
Child Lock
If you choose to lock the buttons on the control
assembly to prevent tampering this function
may be selected.
• Child Lock can be set by pressing the Medic
Rinse button and Pre Wash button
simultaneously. (About three seconds)
• To deactivate Child Lock system, press
Medic Rinse and Pre Wash buttons
simultaneously again. (About three seconds)
• To change to the desired program, whilst in
child lock mode.
1. Press both Medic Rinse and Pre Wash
together once again. (About three seconds)
2. Press the Start/Pause button.
3. Select the desired program and press the
Start/Pause button again.
• The child lock can be set at any time and it
can be deactivated only by using child lock
cancel process. Turning the power off and
operational errors will not affect child lock.
18
Tub Clean
Tub Clean course can be set by pressing
and holding Intensive and Crease Care
button simultaneously.
When Tub Clean course is set, display
" ", and all buttons are inoperable.
TUB CLEAN is special cycle to clean the
inside of the washer. This cycle uses higher
water level with higher spin speed. Perform
this cycle regularly.
How to use the Tub Clean cycle:
1. Remove any clothing or items from the
washer and close the door.
2. Open the dispenser drawer and add Anti
limescale (Calgon) to the Main wash
compartment.
NOTE: Do not add any detergent to the
detergent compartments. Excessive
suds may generate and leak from the
washer.
3. Close the dispenser drawer slowly.
4. Power On and then press and hold
Intensive and Crease Care button for
3 seconds. then "
5. Press the Start/Pause button to start.
6. After the cycle is complete, leave the door
open to dry around the washer door
opening, flexible gasket and door glass.
!
CAUTION: If there is a small child, be
careful not to leave the door
open for too long.
" is displayed in LED