Error Indications On The Front Display - Yamaha MusicCast HTR-4071 Owner's Manual

Error indications on the front display

Refer to the table below when the error message is indicated on the front display.
Message Cause
Access denied Access to the PC is denied.
The unit cannot access the USB device.
Access error
There is a problem with the signal path from the network to the unit.
Check SP Wires The speaker cables short circuit.
Internal Error An internal error has occurred.
No content There are no playable files in the selected folder.
No device The unit cannot detect the USB device.
The network cable is not connected.
Not connected
The wireless router (access point) is not found.
The unit is preparing for connecting to the network.
Please wait
The remote control IDs of the unit and the remote control are not
RemID Mismatch
identical.
The unit cannot play back the songs stored on the iPhone for some
reason.
Unable to play
The unit cannot play back the songs stored on the PC for some
reason.
USB Overloaded An overcurrent is flowing through the USB device.
Version error Firmware update is failed.
Firmware update is failed.
Update failed.
Remedy
Configure the sharing settings and select the unit as a device to which music contents are shared
(p.63).
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Make sure your router and modem are turned on.
Check the connection between the unit and your router (or hub) (p.27).
Twist the bare wires of the cables firmly and connect to the unit and speakers properly.
Contact the nearest authorized Yamaha dealer or service center.
Select a folder that contains files supported by the unit.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Connect the network cable properly.
Make sure the wireless router (access point) is turned on.
Wait until the message disappears. If the message stays more than 3 minutes, turn off the unit and turn
it on again.
Change the remote control ID of the unit or the remote control (p.98).
Check the song data. If it cannot be played on the iPhone itself, the song data or storage area may be
defective.
Ensure that the files are types that the unit is able to play back. For information about the formats
supported by the unit, see "Playing back music stored on media servers (PCs/NAS)" (p.63). If the unit
supports the file format, but still cannot play back any files, the network may be overloaded with heavy
traffic.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Update the firmware again.
Press STRAIGHT and select a firmware updating method, then press INFO to update the firmware
again.
111
En