Sapho BH7001-1 Owner's Manual page 5

 Never keep a filled LP gas tank in a hot car or car trunk. Heat will cause the gas
pressure to increase, which may open the relief valve and allow gas to escape.
 Place dust cap on valve outlet whenever the LP gas tank is not in use. Only install
the type of dust cap on the LP gas tank valve outlet that is provided with the LP gas
tank valve. Other types of caps or plugs may result in leakage of propane.
 Do not store a spare LP gas tank under or near this gas appliance.
 Never fill the tank beyond 80 percent full.
 LP gas cylinders should only be filled by a certified LP gas dealer.
 The pressure regulator is set for 11 inches of water column (pressure).
 The maximum inlet gas pressure for this outdoor appliance is 14 inches of water
column pressure.
 The maximum gas supply pressure is 250psi
 Any guard or other protective device removed for servicing the appliance must be
replaced prior to operating the appliance.
 Installation and repair should be done by a qualified service person. The
appliance should be inspected before use and at least annually by a qualified
service person. More frequent cleaning may be required as necessary. It is
imperative that control compartment, burners and circulating air passageways
of the appliance be kept clean.
 Do not attempt to disconnect the gas regulator from the tank or any gas fitting while
the outdoor appliance is in use.
 Keep gas appliance away from location where it can get excessively wet. Do not use
gas appliance if any part has been underwater. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the control system and
any gas control which has been under water.
 This appliance shall be used only outdoors in a well-ventilated space and shall not be
used in a building, garage or any other enclosed area.
 The LP-gas supply cylinder must be disconnected when this appliance is not in use
 Only cylinder marked "propane" shall be used.
 Be sure to use only one 20 lb (9.1 kg) LP gas cylinder with a Type 1 valve with this
appliance as required by the American National Standards Institute (ANSI) and the
Canadian Standards Steering Committee.
 LP gas cylinder must contain a shut-off valve as specified in the Standard for
Compressed Gas Cylinder Valve Outlet and Inlet Connection, ANSI/CGA-V-1-1977,
CSA B96.
 Never attempt to attach this appliance to the self-contained LP gas system of a
camper trailer, motor home or house.
 Hand turn the manual gas control valve. Never use tools. If the valve will not turn by
hand, do not try to repair it. Call a Certified Gas Technician. The use of force or any
self attempted repair may result in a fire or explosion.
WARNING: Improper installation, adjustment, alteration, service or maintenance can
cause injury or property damage. Refer to the owner's information manual provided with
this appliance. For assistance or additional information consult a qualified installer,
service agency or the gas supplier.
5