Page 1
Blender with Chopper and Mill Model: RM/519 220-240V~ 50-60Hz, 400W Read this booklet thoroughly before using and save it for future reference...
IMPORTANT SAFEGUARDS When using this electrical appliance, basic safety precautions should always be followed, including the following: 1. Read all instructions. 2. Before using check that the voltage indicated on the product corresponds with the voltage of your electrical outlet. 3.
Page 3
23. Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use. 24. This appliance is intended to be used in household and similar applications such as: – staff kitchen areas in shops, offices and other working environments; –...
Page 4
KNOW YOUR BLEANDER Measure cup Blade assembly Seal ring Blade Base Speed knob Motor unit Fig.1...
bowl Lid S blade assemboy Bowl CHOPPER_BOWL SPEED KNOB Fig.2 HOW TO USE Before initial use 1. Before first use, unpack the appliance and place all parts on a horizontal surface. 2. The jar assembly (including the measure cup, lid, seal ring 1, jar, seal ring 2 , blade assembly and jar base) has already been assembled into the motor unit.
Page 6
the lid onto the jar assembly. Place the measure cup exactly into the lid by fitting the small projection on the both sides of the cup into the slots of the lid and turning the cup clockwise until tight. (See Fig.4) 3) Finally, place the assembled jar onto the motor unit by aligning the strip on the assembled jar bottom.
the lid opening. (See Fig.7) 8. When crushing ice or hard food, keep one hand firmly on the lid. 9. When the consistence you desire is obtained, turn the knob to O position. Note: 1) For each use, the consecutive operation time should not exceed 3 minutes. at least 10 minutes rest time must be maintained between two continuous cycles, let the unit cool to room temperature before performing next operation cycle.
Page 8
In addition, detach the jar cover seal ring 1 from the jar cover. Fig.8 Rinse the measure cup, lid, seal ring 1, jar, seal ring 2 and blade assembly by hands or in a dishwasher and then dry. They are dishwasher safe components, but the temperature setting shall not exceed 70℃. 7.