Unpacking Your Refrigerator; Choosing The Proper Location; Flooring - LG LDCS24223 Series Owner's Manual

Unpacking Your Refrigerator

DANGER
.
Use two or more people to move and
install the refrigerator. Failure to do so
can result in back or other injury.
.
Your refrigerator is heavy. When moving
the refrigerator for cleaning or service,
the refrigerator straight out when moving
it. Do not wiggle or walk the refrigerator
could occur.
.
such as gasoline, away from the
refrigerator. Failure to do so can result in
Remove tape and any temporary labels from your
refrigerator before using. Do not remove any
warning-type labels, the model and serial number
label, Installations labels or the Circuit Diagram
located in the backward of refrigerator.
To remove any remaining tape or glue, rub the
area briskly with your thumb. Tape or glue residue
can also be easily removed by rubbing a small
amount of liquid dish soap over the adhesive with
your gers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol,
ammabl uids, or abrasive cleaners to remove
tape or glue. These products can damage the
surface of your refrigerator.
Refrigerator shelves are installed in the shipping
position. Please reinstall shelves according to
your individual storage needs.

Choosing the Proper Location

.
Select a place where a water supply can
be easily connected for the automatic
icemaker.
NOTE
The water pressure must be between
20 and 120 psi (0,138 - 0,82 MPa) on models
120 psi (0,276 - 0,82 MPa) on models with a
.
The refrigerator should always be plugged
into its own individual properly grounded
electrical outlet rated for 115/127 V ~
60 Hz, AC only, and fused at 15 A.
This provides the best performance
and also prevents overloading house
hazard from overheated wires. It is
recommended that a separate circuit
serving only this appliance be provided.
CAUTION
To reduce the risk of electric shock, do not
install the refrigerator in a wet or damp
area.

Flooring

To avoid noise and vibration, the unit must be
leveled and installed on a solidly constructed
front should be slightly higher than the rear to
aid in door closing. The leveling legs can be
turned easily by tipping the cabinet slightly.
Turn the leveling legs to the left to raise the
unit or to the right to lower it. (See Leveling
and Door Alignment.)
NOTE
Installing on carpeting, soft tile surfaces,
a platform or weakly supported structure
is not recommended.
INSTALLATION 12